A how-to guide from Unclog.itWritten by a Red Seal plumber in British Columbia

Bathtubs · 15 to 30 minutes · Updated November 2026

How to unclog a bathtub drain.

A tub with a shower over it clogs with the same hair as a shower stall, but the drain is built differently. There is a stopper instead of a cover, and an overflow that changes how you plunge it and where the snake goes in.

How a tub drain is put together

The drain end of a bathtub, seen from the sideA cutaway drawing showing the stopper, the drain shoe under the tub, the overflow plate, the overflow pipe, the tee where the two meet, the trap and the trap arm.1234567
  1. Stopper. Hair wraps around it and under it.
  2. Drain shoe. The bend under the tub. Too tight for a snake to turn.
  3. Overflow plate. On the end wall of the tub, under the tap.
  4. Overflow pipe. The straight way down to the trap.
  5. Tee. Where the drain and the overflow meet.
  6. Trap. The bend that holds water and keeps sewer gas out.
  7. Trap arm. On to the rest of the house.

Which stopper do you have?

Six kinds of bathtub stopper: lift-and-turn, push-pull, toe-touch, flip lever, trip lever and pop-up
Kinds of bathtub stopper and how each is removed
StopperHow to tellHow it comes out
1. Lift-and-turnA small knob. You lift it and turn it to lock it openOpen it. Hold the body and unscrew the knob counterclockwise. If there is a small set screw on the side, loosen that instead
2. Push-pullA larger knob. Push down to close, pull up to openPull it open, unscrew the knob, then undo the brass post under it with a screwdriver
3. Toe-touchA smooth cap. Press to close, press again to openOpen it and unscrew the cap counterclockwise. Then unscrew the post
4. Flip leverA small toggle on top of the stopperFlip it open and pull or twist the stopper straight out
5. Trip leverA lever on the overflow plate, and only a strainer at the drainUndo the overflow plate screws and draw the plate, rod and plunger out together
6. Pop-upA lever on the overflow plate, and a stopper that rises at the drainLever up. Pull the stopper and its rocker arm out of the drain. The linkage comes out through the overflow

Andrew's pro tip: With a trip lever or pop-up, hair wraps around the linkage inside the overflow pipe where you can't see it. If a tub with one of these is slow and the drain looks clean, that is where to look.

The five steps

  1. A bathtub stopper being unscrewed and lifted out of the drain, with hair caught under it

    Take the stopper out. Most unscrew: open it, hold the body and turn the knob or cap counterclockwise. Pull out the hair wrapped around it and caught on the crossbars underneath.

    Andrew's pro tip: This is where most bathtub clogs are. Run the water for a minute before you do anything else.

  2. The strip pushed down until it stops, then worked up and down so the barbs catch the hair

    Still slow? Run a plastic hair strip down the drain opening. Push until it stops, work it up and down, and pull it back slowly. Three or four passes.

  3. A wet cloth held over the bathtub overflow plate while the drain is plunged

    Next, a plunger. Hold a wet cloth tight over the overflow plate, run a few centimetres of water into the tub, and give it a dozen firm strokes with a cup plunger.

    Andrew's pro tip: The cloth is not optional. Without it the plunger just pumps air in and out of the overflow.

  4. A drain snake fed through the bathtub overflow opening, down the overflow pipe and round the trap

    Last, a hand snake, through the overflow. Unscrew the overflow plate, draw out any linkage attached to it, and feed the cable down the overflow pipe and round the trap, cranking clockwise.

    Andrew's pro tip: Never down the drain opening. The bend under the tub is too tight, and the cable jams at the tee.

  5. The shower running and the water going straight down the drain

    Refit the plate and the stopper. Then fill the tub a third full and pull the plug. A tub that empties with a strong whirlpool and no pause is clear.

Why not down the drain?

A snake pushed down the bathtub drain opening, stuck where the drain meets the overflow pipe, crossed out

The drain opening leads into the drain shoe, a tight bend directly under the tub, and then sideways to a tee. A snake pushed in that way jams at the tee or turns up the overflow pipe. Through the overflow, the cable drops straight down to the trap. It is how a plumber does it.

Stop and call a plumber if

  • The tub fills when the toilet is flushed or the sink drains. That is the main line
  • Water has been standing in the tub for hours
  • There is a water stain on the ceiling below. A worn overflow gasket or drain seal leaks every time the tub is used, and clearing the clog won't stop it
  • The house is old enough to have a drum trap, a round metal canister in the floor beside the tub, instead of a U-shaped trap

In Metro Vancouver and the Fraser Valley, Unclog.it clears a bathtub drain from $329 in regular hours. What the price includes.

Questions

I pulled the hair out and the tub is still slow. Why?

The rest of it is on the stopper linkage or in the trap, out of reach from the drain opening. Plunge it with the overflow covered, then snake it through the overflow.

Why does the tub fill when I flush the toilet?

There is a blockage downstream of both, in the pipe they share or in the main sewer line. Plunging the tub won't fix it. Stop using water and call a plumber.

Can I clear the drain with water still in the tub?

Yes. The strip and the plunger both work through standing water, as long as no drain cleaner has gone in. Don't bail tub water into a toilet that is also slow.

Are bath bombs and bath oils bad for the drain?

In quantity, yes. Oils coat the pipe the way grease does in a kitchen drain, and hair sticks to the coating. Use them sparingly and run hot tap water for a minute afterwards.

More shower drain help

This page is general information, not professional advice for your situation. If you are unsure at any point, stop and call a licensed plumber. See the legal disclaimer.