Hand snake · 20 minutes · Updated November 2026
How to snake a shower drain.
A hand snake is a coiled steel cable in a drum, with a crank. It goes round the trap, winds itself into the hair and brings it back out. It is the last tool to try before calling a plumber.
By Andrew HendersonRed Seal Plumber
When to reach for it
| After the strip and the plunger | A hair strip has come up clean and plunging changed nothing. The clog is in the trap or just past it. |
|---|---|
| When it keeps coming back | The top of the drain gets cleared every few weeks and it clogs again. The rest of it is sitting in the trap. |
| Not when drain cleaner is in | A spinning cable flicks whatever is in the drain. Wait, flush it through if it will drain at all, or call a plumber and tell them. |
Before you start: cover off, gloves and eye protection on, a bucket and a rag beside the drain. The five set-up steps.
The six steps
Use a hand snake with a 1/4 inch cable, sometimes sold as a drum auger. Not a toilet auger, which is too short and too stiff for this bend.
Loosen the thumbscrew and push the cable down the drain by hand until it stops. That first stop is the bend of the trap, not the clog.
Slide the drum down until it is about a hand's width above the drain, then tighten the thumbscrew to lock the cable.
Andrew's pro tip: Keep that gap short. A long loop of loose cable between the drum and the drain is what kinks.
Turn the crank clockwise with steady, gentle pressure. The cable works its way round the bend. Loosen, feed another hand's width, lock, and crank again.
Andrew's pro tip: Always clockwise, going in and coming out. Backwards unwinds the cable and it tangles in the pipe.
When it gets harder to turn and feels springy, you are in the hair. Give it a few more turns so the head winds into it. Don't force it.
Keep turning clockwise as you pull the cable back out, wiping it with a rag as it comes. The hair comes up wrapped round the head.
Andrew's pro tip: Have the bucket beside the drain. What comes up is black and it drips.
In a bathtub, go in through the overflow
Unscrew the overflow plate on the end wall of the tub and pull it away. If a rod or a chain comes with it, that is the stopper linkage. Draw it all the way out and set it aside. Feed the cable into the overflow opening. It drops straight down to the trap.
Down the drain opening is the wrong way. The pipe under the tub turns sharply and then meets the overflow pipe at a tee. A cable jams there, or turns up the overflow instead of down to the trap.
How to not make it worse
- Don't force it. If the crank stops turning, back off a turn and try again. Forcing it kinks the cable, and a kinked cable is finished.
- Keep the gap short. No more than a hand's width of bare cable between the drum and the drain while you crank.
- Clockwise only. Going in and coming out.
- Protect the shower. A turning cable marks acrylic and fibreglass. Lay a rag around the drain opening and keep the cable in the middle of it.
- Go easy in an old house. Cast iron, lead and thin brass drains from before the 1960s can be fragile. If the cable grinds or scrapes on metal, stop.
If it still won't clear
If you have fed two or three metres of cable and the shower is no better, the blockage is past the trap and into the house's piping, or the cable is turning into a fitting instead of following the drain. Either way a hand snake has done what it can. A plumber's drain machine has a stiffer cable, cutting heads, and the reach to follow the line.
Questions
What size drain snake do I need for a shower?
A 1/4 inch cable, 4.5 to 7.5 m (15 to 25 ft) long. A thicker cable is stiffer and has trouble turning through a shower trap. A thinner one tangles.
Can I use a drill-powered snake?
You can, on a low speed, but a hand crank gives you a much better feel for what the cable is doing. Most cables that get kinked or stuck were being driven by a drill.
The cable is stuck. What do I do?
Stop pulling. Turn the crank clockwise while pulling back gently, so the head unwinds from whatever it has caught. If it will not come free, leave it where it is and call a plumber. A cable snapped off in the trap is a much harder job.
Will a snake damage my pipes?
Not a 1/4 inch hand snake in sound plastic or copper pipe. The risk is in old, corroded metal drains, where a cable can break through a pipe wall that was already thin.
More shower drain help
This page is general information, not professional advice for your situation. If you are unsure at any point, stop and call a licensed plumber. See the legal disclaimer.
